List of Papers
- CFD wind-driven rain simulations and their use for HAM modeling
- Hygric and thermal properties of alkali activated alumosilicate material
- Inverse modeling of salt diffusion and advection in building materials
- Hydrophilic mineral wool materials: The effect of fiber orientation
- Whole building approach and hygrothermal risk analysis
- Vacuum insulated building envelopes
- On the performance of vacuum insulated panels and sandwiches
- Influence of rain water percolation on ground heat losses and temperature for basement foundation
- Acoustical performances of ventilated double glass façades
- Performance of wind scoops as ventilation retrofitting in tropical tall buildings
- Transient moisture transfer between spruce plywood and humid air
- On validation of hygric characteristics for heat, air, moisture models
- The climate adapted design of buildings: An easy way for the optimization
- Thermal testing and numerical simulation of a prototype cell using light wallboards coupling Vacuum Isolation Panels (VIP) and Phase Change Material (PCM)
- Thermal comfort in residential buildings with passive and active acclimatization
- Disturbances and operational parameters of central heating systems in retrofitted buildings
- Moisture buffer value: A comprehensive analysis of essential parameters based on experimental data
- Heat flow into the ground from the heated slab-on-ground structure – Field measurements
- Moisture performance characteristics of OSB and spruce plywood exterior sheathing products
- Effect of airflow velocity on moisture exchange at surfaces of building materials
- Urban Building Physics: a CFD study of the Venturi-effect in non-parallel passages between buildings
- Local wind speed near exterior building surfaces for convective transfer coefficients
- Sustainable construction -A simplified methodology for optimal design
- Learning from experience – An analysis of process induced building defects in Norway
- Empirical validation of solar gain modeling in building energy simulation codes using test cells in IEA Task 34/Annex 43
- Normative thermal comfort assessment
- Radiative cooling in buildings for climatic concept of Morocco
- Hygrothermics of wooden beam ends in envelope parts of buildings
- Dynamical interactions between heat and mass flows in lime-hemp concrete
- The application of modern principles of double ventilated roofs using stone as the main roofer in the renovation of the medieval buildings
- Moisture management in the building process – Experience from four projects
- Prevention of algae and mould growth on facades by coatings with lowered long-wave emission
- New model for the hygrothermal calculation of condensate on the external building surface
- Reduced-scale air modeling technique for naturally ventilated buildings
- The compatibility of finishing layer and external surface of buildings walls from the standpoint of durability
- Use of low cost photosensitive sensors in scale models for day lighting studies
- Performance evaluation of hybrid ventilation system for residential buildings
- New design model for frost protection of a slab on grade
- Earth-air heat exchangers: Performance prediction assessment
- Climate adapted wooden cladding design - Field investigation and numerical validation
- Statistical analysis of wooden cladding moisture response to climate parameters
- Utilization of daylight in offices; monitoring in a sample of ten buildings
- Acoustic performance of lightweight plasterboard walls, empirical study on the effect of plasterboard fixing conditions
- Thermal- hygrometry comfort in university classrooms: experimental results in north and central Italy universities conducted with new methodologies based on the adaptive model
- “Exergy”-conscious design in the built environment
- CFD modeling of HAM transport in buildings: Boundary conditions
- Evaluation strategy of finishing materials contribution to the hygroscopic inertia of a room
- Energy performance of timber houses in northern Italy
- Exploration of a transient method for measurements of airtightness
- Combining expansion/shrinkage monitoring and X-ray measurement for water and salt transport in calcium silicate beam
- An X-ray apparatus for advanced construction related moisture research
- Climate change, hygrothermal modeling and the indoor environment
- Airflow between houses and their roofs
- Comparison of measured and modeled driving rain data on a historic building with standard assessment methods
- Effects of passive solar heat on energy use and indoor temperatures in residential buildings
- Upgraded weather forecast control of building heating systems
- Decreasing the risk of moisture damage to prefabricated building components –>From production to construction
- Thermal mass in office buildings
- A simplified calculation method of the annual energy use for space heating and cooling: Assessment of the dynamic parameters for the Italian building stock and climate
- Energy assessment of heating consumption in existing school buildings: Results of a field survey
- Real world glazing & window frame performance – Designing to mitigate condensation
- Solar factor for ventilated roofs
- Hygric buffering capacities of uncoated and coated gypsum board
- Simulation tests in whole building heat and moisture transfer
- Hygrothermal simulation of masonry under atmospheric excitation
- Evaluation of instantaneous profile measurements indicating dependencies of moisture transport on hysteresis and dynamics
- Experimental investigation of the hygric buffering capacity of wood based interior paneling
- Hygrothermal performance of unfinished attics (ventilated roofs) –An experimental study
- Measurement of water retention and moisture conductivity at transient conditions
- Probabilistic modeling of energy performance of a building envelope
- Building energy– A design tool meeting the requirements for energy performance standards and early design - Validation
- A multi-physics model for cyclic loading
- Protocol and results of a residential short term room air temperature test
- Climate adapted building design for Hesquiaht First Nation school
- Predicting and modeling the effects of wall cladding ventilation on sun-driven condensation
- The influence of salt on hygrothermal behavior of building materials
- The influence of construction material moisture on the indoor humidity and surface conditions
- Biodegradation of VC-VAc copolymer under the effect of microorganisms
- Liquid water transport in wood: Towards a mesoscopic approach
- Performance assessment of innovative transparent active envelopes through measurements in test cells
- Optimization of passive application of phase-change materials in building walls
- Comparison of sensible and latent thermal storage potential of double-skin façade
- CFD study of natural ventilation between multiple spaces with stratification
- Edge loss minimization in vacuum insulation panels
- Simulating transient particle deposition/re-suspension in indoor environments
- An extendible material database for indoor air quality and hygrothermal research and applications
- Modeling of indoor-outdoor air-exchange in a multi-unit residential building
- Ventilation drying in walls with vapor impermeable claddings
- A new approach for the IEQ (indoor environment quality) assessment
- Experimental assessment of environment performance of different typologies of light pipes
- Mathematical model of the thermal performance of a dome-covered house
- Evaluating the energy performance of ballasted roof systems
- Second law analysis of HVAC systems for office buildings
- Understanding air barriers in mechanically attached low slope roofing assemblies for wind uplift
- Convection phenomena in loose-fill attics – Tests and simulations
- Hygrothermal modeling of aerated concrete wall and comparison with field experiment
- Economy, energy and ecology based comparison of heating systems in dwellings
- Indoor climate for comfortable sleep, considering heat and moisture transfer between the room, bedding and human body: Air control system using a predictive model for thermal comfort
- Development of extremely low energy dwellings through life cycle optimization
- A low-energy building under arctic conditions -A case study
- Influences of acid rain on neutralization process
- Wind induced thermal losses through compact pitched roof constructions - Test roof– measurements, simulation model and validation
- Steady-state moisture diffusion in Scots pine -The influence from distance to pith
- Critical moisture contents for water and air transport in case of imbibition and drying tests
- Determination of porosity related property changes in bricks after penetration with paraffin
- Performance of edge sealing systems used in moisture transport experiments
- Test method to study the water shedding effectiveness of drip-edge of metal flashing
- Numerical modeling of impact, runoff and drying of wind-driven rain on a window glass surface
- Building envelope performance monitoring and modeling of west coast rainscreen enclosures
- BEPAT - Building envelope performance assessment tool: Validation
- In-situ measurement of the moisture content of building materials using ultra-wideband radio waves
- Analysis of Montreal 30-year weather data to select loading conditions for large-scale tests on wall panel systems
- Establishing a uniform and measurable moisture source to evaluate the drying capacity of building envelope systems
- Experimental evaluation of potential movement of airborne mold spores out of building envelope cavities using full size wall panels
- Large scale experimental investigation of the relative drying capacity of building envelope panels of various configurations
- CFD and full scale examination of the pressure distribution around a building corner
- Measured ventilation rates in water managed wall cavities
- A simple and useful method to detect and pinpoint envelope failures during field testing of a gypsum sheathed wall
- The Rijksmuseum Amsterdam - Hygrothermal analysis and dimensioning of thermal insulation
- Incorporation of salt related effects into a hygrothermal transport model
- Moisture atlas for building envelopes
- Evaluation of thermal performance of traditional and modern residential buildings in the hot dry climatic zone of Turkey
- The role of building engineering on integrated design and building sustainability
